MST
RFQ cartCart

Tungsten probe selection: tip radius, shank diameter and a length discrepancy

Need a part from this thread? Let MST find it

This thread is attached to your request. Add the part, your email and quantity; no account needed.

Can't find this part? We'll source it

Send us the part number and quantity. An MST engineer will source it, check that it fits your application, and reply with a quote.

A request for a “7 µm tungsten probe” needs one more detail: which dimension does 7 µm describe? This MST reading example separates tip geometry from the shaft that fits into the holder.

1. Three rows from the manufacturer selection guide

SemiProbe lists the following tip radii:
These three rows specify tungsten tips and shanks, with a 20 mil (0.020 in) shank diameter. The differing tip radius does not imply a differing shank diameter.
Source: SemiProbe Probe Tip Selection Guide, checked 18 October 2026: https://semiprobe.com/probe-station-product-lines/accessories/probe-tips

2. Work through the units

1 mil is 0.001 inch. Therefore: 20 mil = 0.020 in = 0.508 mm. 7.0 µm = 0.007 mm.
The first value describes the shank diameter; the second is the DC-11006 tip radius. Neither is automatically the diameter of the actual electrical contact patch. Keep the dimension name next to every number in a comparison sheet.

3. An unresolved source inconsistency

The manufacturer's table gives overall length as 35 mm (1.25 in). These are not equivalent: 1.25 in is 31.75 mm. Preserve both printed values in your source record, mark the length as unresolved, and request a current drawing or written clarification. Do not silently choose one value or “correct” the manufacturer's specification.

4. A replacement worksheet

Compare the existing and proposed probe against the same fields:
  • Exact probe reference and drawing revision.
  • Tip material, tip radius and tip shape.
  • Shank diameter, holder opening and clamping arrangement.
  • Required installed length, bend geometry and usable reach.
  • Electrical test pad material and dimensions, measurement purpose and operating conditions.
  • Contact-force or overtravel limits from the relevant equipment/probe documentation.
Separate “documented”, “measured on our setup” and “still unknown”. Before qualifying a change, agree how contact repeatability, measurement consistency and electrical test pad condition will be checked on representative samples. This is a suggested comparison workflow, not a test report or a process setting supplied by SemiProbe.
The same material or a similar model number is insufficient to establish fit or measurement suitability. No interchangeability test was performed for this note.
If you have a non-confidential holder drawing or an ambiguous dimension, identify the field in a reply so the discussion can focus on the missing evidence. The related Store reference is: https://mstchip.com/store/tungsten-probe-tips/SC-PROBE-RFQ
MST technical editorial | Version 1 | 18 October 2026
Parts
Catalog parts in this guide

Replies (0)

No replies yet.

Can't find this part? We'll source it

Send us the part number and quantity. An MST engineer will source it, check that it fits your application, and reply with a quote.