5130UP discussions
5130UP (MORISEAL): 5 discussions. AS568-012 O-rings: FFKM vs FKM 75A, and which Morisz grade for which seal; O-ring failure modes in semiconductor tools
Need 5130UP? Let MST find it and quote
The part number and this page are pre-filled. Add your email and quantity; no account needed.
Can't find a part, or don't want to search? Tell MST
Describe what you need. MST checks sources and substitutes for you, and the thread stays useful to other engineers.
Prefer a direct quote? Send MST a sourcing RFQ for this part.
Catalog products
AS568-012 O-rings: FFKM vs FKM 75A, and which Morisz grade for which seal
**Short answer:** AS568-012 is one size (ID 9.25 mm × CS 1.78 mm). The choice is the compound. FKM 75A covers general vacuum, gas and fluid seals up to about 205 °C. Plasma, aggressive chemistry or higher heat points to FFKM, and the MORISE
O-ring failure modes in semiconductor tools: read the failed seal, then choose the elastomer by chemistry and temperature
**Short answer:** Before you reorder a failed O-ring, look at it in cross section. A ring with flat sides and no rebound has taken a compression set. Material squeezed into the clearance gap means extrusion. An oversized, soft ring has swel
AS568 O-ring sizes in 5 minutes: dash-number series, squeeze worked example and FKM vs FFKM choice
**Short answer:** An AS568 dash number fixes the inside diameter and the cross section, and the first digit gives the cross-section series. Material and hardness are specified separately. Size the ring from the groove, check the squeeze, th
Selecting FFKM AS568 O-rings for semiconductor tools: FFKM vs FKM vs EPDM, grade by process and RFQ checklist
**Short answer:** Use FFKM where a seal sees fluorine or oxygen plasma, temperatures above the roughly 204 °C limit of FKM, or chemicals that FKM does not tolerate, such as amines and ammonia. Choose the FFKM grade by process step, not just
Semiconductor FFKM O-ring selection: MORISEAL Morisz grades and application limits
Choosing semiconductor FFKM O-rings starts with the sealing duty, then the material grade and the finished dimensions. The same polymer family does not make every compound interchangeable. This guide organizes MORISEAL's published Morisz ma