AS568-120 discussions
AS568-120: 4 discussions. O-ring failure modes in semiconductor tools: read the failed seal, then choose the elastomer by chemistry and temperature; AS568
Need AS568-120? Let MST find it and quote
The part number and this page are pre-filled. Add your email and quantity; no account needed.
Can't find a part, or don't want to search? Tell MST
Describe what you need. MST checks sources and substitutes for you, and the thread stays useful to other engineers.
Prefer a direct quote? Send MST a sourcing RFQ for this part.
Catalog products
O-ring failure modes in semiconductor tools: read the failed seal, then choose the elastomer by chemistry and temperature
**Short answer:** Before you reorder a failed O-ring, look at it in cross section. A ring with flat sides and no rebound has taken a compression set. Material squeezed into the clearance gap means extrusion. An oversized, soft ring has swel
AS568 O-ring sizes in 5 minutes: dash-number series, squeeze worked example and FKM vs FFKM choice
**Short answer:** An AS568 dash number fixes the inside diameter and the cross section, and the first digit gives the cross-section series. Material and hardness are specified separately. Size the ring from the groove, check the squeeze, th
Selecting FFKM AS568 O-rings for semiconductor tools: FFKM vs FKM vs EPDM, grade by process and RFQ checklist
**Short answer:** Use FFKM where a seal sees fluorine or oxygen plasma, temperatures above the roughly 204 °C limit of FKM, or chemicals that FKM does not tolerate, such as amines and ammonia. Choose the FFKM grade by process step, not just
AS568 dash numbers for FFKM O-rings: reading cross-section families, the three "25 mm" rings, and the Kalrez shrinkage note
**Short answer:** An AS568 dash number fixes both the inside diameter (ID) and the cross-section (CS) of an O-ring. In the DuPont Kalrez AS-568 dimensions table, sizes -004 to -050 are 1.78 mm (.070 in) cross-section and the -1xx sizes are